- This topic has 6 replies, 5 voices, and was last updated 3 years, 7 months ago by Rachel Pingel.
Viewing 7 posts - 1 through 7 (of 7 total)
-
AuthorPosts
-
October 24, 2019 at 11:05 pm #155707
Rachel PingelParticipantKickstarter being run by a younger member of the toy community(his father set up the kickstarter). He’s hoping to have his toy made in vinyl!
October 26, 2019 at 5:05 am #155786
Mark-AnthonyParticipantThis is cute!
November 21, 2019 at 5:54 pm #160416
Philip PageParticipantI saw this young fella posting about it on Reddit. Offered him encouragement but he’s unlikely to fund but I don’t think it’s the last we’ll see of him. 😉
December 16, 2019 at 11:54 pm #164144
Rachel PingelParticipantYeah I hope he tries again! Takes a lot to get a kickstater noticed!
December 19, 2019 at 3:34 pm #164558
Raul MartinezParticipantSeen the young man on Reddit as well, very active and hopefully he can his project off the ground.
August 12, 2020 at 12:28 pm #193508
Micah youngParticipantI wonder if he got it funded??
September 11, 2020 at 12:10 am #196362
Rachel PingelParticipantI beleive he did! I noticed the other day that Tenacious Toys have one available! https://www.tenacioustoys.com/products/common-splat-4-inch-resin-figure-by-splatoys
-
AuthorPosts
Viewing 7 posts - 1 through 7 (of 7 total)
You must be logged in to reply to this topic.